Injury Illness Prevention Plan - Flipbook - Page 107
Health and Safety Program Manual
Teamwrkx
Construction, Inc.
Issue Date: 10/16/23
Revision Date: 10/16/23
Gas Monitors
Reference: A-4
This Guidance Document is offered and provided by Teamwrkx Construction, Inc. as guidance to assist its
subcontractor partners in complying with the minimum requirements of the Clients they are connected to
and/or facilities they are registered for, as well providing other helpful information to assist in the
development of successful safety programs that address potential exposure hazards for employees. The
information and material in this Guidance Document is offered for informational purposes only and
Teamwrkx Construction does not make any warranties or representations with respect to the content,
quality, accuracy or completeness of any information or material contained herein. TEAMWRKX
CONSTRUCTION EXPRESSLY DISCLAIMS ANY WARRANTY OF MERCHANTABILITY, FITNESS FOR A PARTICULAR
PURPOSE, TITLE, OR INFRINGMENT OF THE INTELLECTUAL PROPERTY RIGHTS OF A THIRD PARTY, WHETHER
EXPRESS OR IMPLIED BY LAW, COURSE OF DEALING, COURSE OF PERFORMANCE, USAGE OF TRADE, OR
OTHERWISE. Teamwrkx Construction assumes no legal liability for the content, quality, accuracy, or
completeness of the information or material contained in this template. In no event will Teamwrkx
Construction be liable for any damages, whether direct, indirect, general, consequential, incidental,
exemplary, or special, arising from the use of this template. This template has been made available for general
use only on an “as-is” basis. All access to, and use of, this template is at the member’s risk. It is the
responsibility of the member to ensure that the information contained in this template is suitable for the
purpose and applicable to the member. This includes but is not limited to ensuring that the program addresses
applicable legislation.
PURPOSE
To ensure proper use and accuracy of gas monitors, which will be used where hazardous gases may exist.
SCOPE
This section applies to all workers who will be either using a personal gas monitor or performing work on a job
site where continuous air monitoring is required pertaining to the service provided by COMPANY NAME;
hereafter referred to as “The Company”.
DEFINITIONS
Zero (fresh air) Calibration – This is done in a clean atmosphere of 20.9% oxygen and no detectable VOC, toxic,
or combustible gases. It is used to set the zero point for each sensor.
Span Calibration – is the set of operations that establish, under specified conditions, the relationship between
the values of quantities indicated by a measuring instrument and the corresponding values realized by given
standards. Note: Refer to the gas bottle label for specific values.
Bump Testing – Ensures that all sensors are reading accurately according to the set values of the gas being
applied. Note: Refer to the gas bottle label for specific values.
1
