Injury Illness Prevention Plan - Flipbook - Page 80
Health and Safety Program Manual
Teamwrkx
Construction, Inc.
Electrical - Qualified
Arc Flash Safety
Issue Date: 10/16/23
Revision Date: 10/16/23
Reference: A-1
This Guidance Document is offered and provided by Teamwrkx Construction, Inc. as guidance to assist its
subcontractor partners in complying with the minimum requirements of the Clients they are connected to
and/or facilities they are registered for, as well providing other helpful information to assist in the
development of successful safety programs that address potential exposure hazards for employees. The
information and material in this Guidance Document is offered for informational purposes only and
Teamwrkx Construction does not make any warranties or representations with respect to the content,
quality, accuracy or completeness of any information or material contained herein. TEAMWRKX
CONSTRUCTION EXPRESSLY DISCLAIMS ANY WARRANTY OF MERCHANTABILITY, FITNESS FOR A PARTICULAR
PURPOSE, TITLE, OR INFRINGMENT OF THE INTELLECTUAL PROPERTY RIGHTS OF A THIRD PARTY, WHETHER
EXPRESS OR IMPLIED BY LAW, COURSE OF DEALING, COURSE OF PERFORMANCE, USAGE OF TRADE, OR
OTHERWISE. Teamwrkx Construction assumes no legal liability for the content, quality, accuracy, or
completeness of the information or material contained in this template. In no event will Teamwrkx
Construction be liable for any damages, whether direct, indirect, general, consequential, incidental,
exemplary, or special, arising from the use of this template. This template has been made available for general
use only on an “as-is” basis. All access to, and use of, this template is at the member’s risk. It is the
responsibility of the member to ensure that the information contained in this template is suitable for the
purpose and applicable to the member. This includes but is not limited to ensuring that the program addresses
applicable legislation.
PURPOSE
The purpose of this program is to set forth procedures for the safe use of electrical equipment, tools, and to
comply with NFPA 70E requirements. Qualified workers who perform electrical activities in or around arc flash
must adhere to the requirements of this program.
SCOPE
This program applies to all COMPANY NAME, hereafter referred to as “The Company”, workers. When work is
performed on a non-owned or operated site, the operator’s program shall take precedence, however, this
document covers The Company workers and contractors and shall be used on owned premises, or when an
operator’s program doesn’t exist or is less stringent.
The Company shall advise the host employer of:
x
x
x
Any unique hazards presented by the contract employer’s work,
Any unanticipated hazards found during work by The Company that the host employer did not
mention, and
The measures the company took to correct any hazards reported by the host employer to prevent
such hazards from recurring in the future.
1
